TM 5-3805-262-34
REMOVAL ( SHEET 1 OF 5)
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
Wear protective goggles and gloves and use only in a well ventilated
area. Avoid contact with skin, eyes and clothes and don’t breathe
vapors. Do not use near open flame or excessive heat and don’t smoke
when using it. Failure to do so could cause serious injury. If you be-
come dizzy while using cleaning solvent, get fresh air and medical
attention
with large
with water
(1) Clean
cloth
immediately.
If cont-act with skin or clothes is made, flush
amounts of water. If contact with eyes is made,
and get medical aid immediately.
area around fuel injectors and fuel injection pump
moistened with cleaning solvent P-D-680.
wash eyes
using clean
NOTE
Injector tube key numbers correspond to engine cylinder numbers. For
example, injector tube (1) connects to number 1 cylinder fuel injector
nozzle.
(2) Tag injector tubes (1 thru 6).
In following step, don’t hit fuel injector leak off fitting with
Crowsfoot wrench. To do so will break fuel injector leak off fitting.
(3) Using a 11/16 inch Crowsfoot wrench, loosen and disconnect injector tubes
(1 thru 6) from fuel injector nozzles.
(4) At fuel injection pump, loosen and disconnect injector tubes (1 thru 6)
from pump.
3-117
