TM 5-3805-262-34
3-2. FUEL SYSTEM MAINTENANCE (CONT)
b. Fuel Injection Lines (Cont).
INSTALLATION (SHEET 1 OF 5)
NOTE
Perform following two steps only if sleeves (35 and 38), compression
nuts (33 and 37), or pipe tee (40) were removed, otherwise go to step
(3) below.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
LEGEND
Slide compression nuts (33 and 37) and sleeves (35 and 38) onto ends of
oil tube (34).
Install pipe tee (40) in engine block and tighten.
Connect male end of oil hose (39) to pipe tee (40) and tighten.
Connect swivel end of oil hose (39) to air compressor and tighten.
Install and tighten elbow (36).
Position oil tube (34) with compression nuts (33 and 37) and sleeves (35
and 38).
Push oil tube (34) into pipe tee (40) and tighten compression nut (37).
Push free end of oil tube (34) into elbow (36) and tighten
nut (33).
compression
330 Compression nut
34. Oil tube
35. Sleeve
36. Elbow
37. Compression nut
38. Sleeve
39. Oil hose
40. Pipe tee
3-124
