TM 5-3805-262-343-2.FUELSYSTEMMaintenance(CONT)b. FuelInjectionLines(Cont).INSTALLATION (SHEET 3 OF 5)(12) Loosely connect leak off tubes (29and 30) to fuel injector nozzles astagged. This will aline each fuelinjector with other injectors.(13) Put a 3/8 inch open end wrench onflats of fuel injector body tohold fuel injector in alinementwith other fuel injectors.(14) Tighten fuel injector body retain-ing nut to 35 to 45 lb-ft using7/8 inch Crowsfoot wrench.NOTERepeat steps (13) and (14) above to tighten remaining fuel injectors.(15) Using a Crowsfoot wrench, tighten compression nuts (28) on leak off tubes(29 and 30) and tubular rivet (32) to 35 to 45 lb-ft.NOTEperform following steps only if check valve (27), sleeves (23 and 26),or compression nuts (21 and 24) were removed, otherwise go to step (20)below. For installation of fuel tank hose (25) refer to TM 5-3805-262-20.(16) Install check valve (27) in fuel injection pump and tighten.(17) Slide compression nut (24) and sleeve (26) onto end of fuel tank hose.(18) Push fuel tank hose (25) into check valve (27) and tighten compressionnut (24).(19) Slide one compression nut (21) and sleeve (23) onto each end of leak offtube (22).(20) Position leak off tube (22) with compression nuts (21) and sleeves (23).(21) Tighten compression nut (21) at check valve (27) hand tight only. Tightencompression nut (21) at fuel injector nozzle to 35 to 45 lb-ft using aCrowsfoot wrench.3-126
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business