TM 5-3805-262-34
3-2. FUEL SYSTEM MAINTENANCE (CONT)
c. Fuel Feed Pump (Cont) .
REASSEMBLY
LEGEND
6. Gasket
7. Filter element
8. Spring
9. Fuel bowl
10. Bail
11. Setscrew
12. Lock nut
13. Plug
14. Gasket
15. Spring
16. Plunger
17. Spindle
18. O-ring
190 Plugs (2)
20. Gaskets (2)
21. Springs (2)
22. Valves (2)
23. Retaining ring
24. Tappet
25. Roller
26. Pin
27. Sliding blocks (2)
28. Body
Lubricate all moving parts with clean engine oil before reassembly.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(lo)
(11)
Position roller tappet (24, 25, and 26) in body (28) bore while instal-
ling two sliding blocks (27).
Install retaining ring (23).
Install two valves (22), springs (21), gaskets (20), and plugs (19) in
body (28) bores.
Install new O-ring (18) on spindle (17).
Position spindle (17), plunger (16), and spring (15) in body (28) bore.
Install gasket (14) and plug (13).
Install bail (10) on body (28).
Position spring (8) and filter element (7) in fuel bowl (9).
Swing bail (10) out of way and position new gasket (6) and fuel bowl (9)
on body (28).
Position setscrew (11) with locknut (12) on bail (10).
Swing bail (10) into position under fuel bowl (9) and tighten lock nut
(12) finger tight. -
3-134
