TM 5-3805-262-343-2. FUEL SYSTEM MAINTENANCE (CONT)d. FuelInfectionPump (Cont).DISASSEMBLY (SHEET 3 OF 8)(13) Remove end plate with camshaft and bearings as an assembly:(a) Gently tap governor end of camshaft using a plastic mallet to loosen endplate. If necessary, use mechanical puller and yoke with slide hammer.(b) Carefully pull end plate with camshaft from housing. Be sure intermedi-ate bearing is removed with camshaft.(14) Using hammer and socket wrench as shown, drive six tappet plugs (27) intocamshaft compartment of housing. Reach into camshaft compartment and re-move tappet plugs. Discard tappet plugs.3-142
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business