TM 5-3805-262-34
(4) At bottom side of hydraulic reservoir, loosen and remove lock nut and
capscrew from cylinder end of steering cylinder assembly.
(5) Using hammer and one inch diameter rod, drive pin from cylinder eye.
Steering cylinder assembly weighs approximately 42 pounds. Be careful
when performing following step not to let cylinder assembly fall. Fail-
ure to do so could cause cylinder assembly to fall and crush your foot.
If you are injured by falling equipment, obtain medical aid immediately.
(6) With assistant supporting cylinder end of steering cylinder assembly,
pull rod end from welded brackets on front of rear chassis. Remove steer-
ing cylinder assembly from front chassis by pulling towards rear of
loader.
NOTE
Repeat above steps to remove remaining steering cylinder assembly.
3-563
