TM 5-3805-262-34INSTALLATION (SHEET 2 OF 2)(8)(9)(10)(11)(12)(13)(14)(15)(16)(17)Tell assistant to turn off engine.Start pin into rear chassis bracketand rod eye. Be sure capscrew hole inpin is alined with hole in chassisbracket.Drive pin into position to secure rodend of steering cylinder assembly.Install capscrew and lock nut. Tight-en lock nut securely.Lubricate two lubrication fittings onsteering cylinder assembly (refer toLO 5-3805-262-12).Repeat steps (6) through (12) tocomplete installation of remainingsteering cylinder assembly.Check hydraulic reservoir oil level. Add oilif level is low (refer to TM 5-3805-262-20).Disengage transport/service link (refer to TM 5-3805-262-10).Start engine and operate at idle speed. Turn steering wheel all the wayright then left several times to remove air from steering cylinder assem-blies. Turn off engine.Check for hydraulic oil leakage at hose connections to steering cylinderassemblies. Tighten connections as necessary.3-565
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
