TM 5-3805-262-343-19. BODY AND CAB MAINTENANCE (CONT)c. Door Assemblies (Cont).REMOVAL (SHEET 2 OF 2)(6) Remove two carriage bolts (6), nuts (7), lock washers (8), and washers(9).(7) Remove two hinge assemblies (10) and hinge bracket (11) from cab.(8)Unlatch and swing open lower door (12).(9) Remove and discard two cotter pins (1).(10) Support lower door (12), drive out two hinge pins (2), and remove twowashers (3).(11) Remove lower door (12) from cab.(12) Remove two hinge brackets (5).(13) Remove two carriage bolts (6), nuts (7), lock washers (8), and washers(9).(14) Remove two hinge assemblies (10) and hinge bracket (11) from cab.Do not perform followingreplacement of seal (13).(15) Remove seal (13) fromDISASSEMBLY (SHEET 1 OF 2)NOTEstep unless inspection indicates need forcab.(1) Disassemble upper door assembly by removing two capscrews (14), nuts(15), lock washers (16), and upper door latch (17) from upper door (4).(2) Disassemble lower door assembly (18 thru 52) as follows:(a) Remove seals (18 and 19) from lower door (12).(b) Remove five capscrews (20), lock washers (21), and washers (22).(c) Remove panel door cover (23).(d) Remove four clip nuts (24) and nut (25).(e) Loosen setscrew (26) and remove handle (27).(f) Remove screw (28), lock washer (29), and washer (30); remove latch cover(31) from lower door (12).(g) Remove foam strip (33).(h) Remove foam pad (32).3-590
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business