TM 5-3805-262-34REASSEMBLYa.If removed, install two new bushings (13) in bracket (14) with chamfer in-ward. Install bushings until flush with large diameter surface of bracketusing hammer and one inch diameter rod or sleeve.b.Put collar (10) and spring (11) on control shaft (9), with loop of spring onpin welded to collar.c.Insert control shaft (9) through bracket (14) bushings (13).d.Slide collar (7) on control shaft (9).e.Put washer (4) and control lever (3) on control shaft (9) with control levermatch mark alined with bracket (14) match mark.f.Aline match marks on control shaft (9) and bracket (14). Install and tightenwasher (2) and lock nut (1) on control shaft threads.g.Push control lever (3) toward bracket (14) as far as it will go and tightensetscrew (6).h.Put spacer (12) on pin welded to collar (10). Hook end of spring (11) oncutout portion of bracket (14). Push collar against spring to compressspring against bracket and tighten setscrew (8).i.If removed, install knob (5) on control lever (3).LEGEND1. Lock nut2. Washer3. Control lever4. Washer5. Knob6. Setscrew7. Collar8. Setscrew9. Control shaft10. Collar11. Spring12. Spacer13. Bushings (2)14. Bracket3-735
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business