TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0177 08
427-B1850
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear diagnostic codes when original diagnostic code has been
corrected. Ensure diagnostic code CID 0177 FMI 08 is active before performing
this procedure.
1. Check for power at sensor.
1. If voltage is 8.0 DCV, go to Test 2.
(a) Do not disconnect harness connector
2. If voltage is not 8.0 DCV, circuit is
from sensor.
open. Replace wiring harness in
(b) At back of sensor harness connector,
question (WP 0169 00 thru WP 0175
insert multimeter probe along voltage
00).
supply wire (contact C).
(c) Turn engine start switch and battery
disconnect switch to ON position (TM
(d) Measure voltage from contact C to
frame ground.