TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check for a short to ground.
1. If resistance is greater than 5,000
0262 04 -
(a) Turn engine start switch and battery
Ohms, verify same diagnostic code is
Cont.
disconnect switch to OFF position (TM
present. If diagnostic code is still
present, replace machine ECM (WP
(b) Disconnect wiring harness from
0052 00).
machine ECM (WP 0052 00).
2. If resistance is less than 5.0 Ohms, go
(c) At machine ECM harness connector,
to Test 3.
measure resistance between frame
ground and contact J1-21 (L740 BR).
1. If, after disconnecting a particular
3. Disconnect sensors.
sensor, resistance changes and is
(a) Engine start switch and battery
greater than 5,000 Ohms, replace
disconnect switch remain in OFF
sensor.
position.
2. If, after disconnecting all sensors,
(b) One at a time, disconnect any sensor
resistance is less than 5.0 Ohms,
that uses power supply from wiring
replace wiring harness in question (WP
harness.
0169 00 thru WP 0175 00).
(c) After disconnecting each sensor, check
resistance from frame ground to
contact J1-11 at ECM harness
connector.
0009 00-25