TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
N OT E
0271 05 -
Cont.
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 0271 FMI 05 is active before per-
forming this procedure.
1. Check alarm.
1. If diagnostic code remains active, go to
(a) Turn battery disconnect switch and
Test 2.
engine start switch to ON position. Do 2. If diagnostic code is no longer active,
not start engine (TM 5-3805-290-10).
repeat this test to verify alarm failure.
(b) Disconnect alarm from wiring harness.
Replace alarm (WP 0051 00). Verify
(c) At alarm wiring harness connector,
new alarm corrects problem.
place a jumper wire from contact 1
(wire H414 YL) to contact 2 (wire 201
BK).
(d) Connect MSD (WP 0006 00) and
observe status of CID 0271 FMI 05.
2. Check harness for an open circuit.
1. If resistance is less than 5.0 Ohms, go
(a) Turn engine start switch and battery
to Test 3.
disconnect switch to OFF position (TM 2. If resistance is greater than 5,000
Ohms, there is an open circuit in wire
(b) Disconnect wiring harness
H414 YL or in wire 201 BK of wiring
connector(s) from instrument cluster
harness. Replace wiring harness in
(WP 0051 00).
question (WP 0169 00 thru WP 0175
(c) Jumper wire installed in Test 1 remains
00).
in place.
(d) At wiring harness connector, measure
resistance from signal contact IC-23
(wire H414 YL) to contact IC-2 (wire
201 BK).
3. Verify diagnostic code remains active.
1. If CID 0271 FMI 05 is active, replace
(a) Inspect and clean harness connectors.
instrument cluster (WP 0051 00).
(b) Reconnect all harness connector
2. If CID 0271 FMI 05 is not active, initial
contacts.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection at a
engine start switch to ON position (TM
harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Check status of CID 0271 FMI 05.
0009 00-28