TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
10. Check circuit from ECM to relay.
1. If, during self-test, indicator for
0795 07 -
(a) Turn engine start switch to OFF
secondary steering system illuminates,
Cont.
position (TM 5-3805-290-10).
replace machine ECM (WP 0052 00).
(b) Remove wire K748 OR from contact 2. If, during self-test, indicator for
J2-9 at ECM.
secondary steering system does not
(c) Using a jumper wire, connect wire
illuminate, wire K748 OR has failed.
K748 OR to frame ground.
Replace wiring harness in question
(d) Turn engine start switch to ON position
(WP 0169 00 thru WP 0175 00).
(TM 5-3805-290-10). During self-test
for secondary steering system, monitor
indicator for secondary steering
system.
1. Verify these hardware and software part
1. If all part numbers are correct, go to
0811 09
numbers:
Test 2.
(a) Connect MSD (WP 0006 00).
2. If all part numbers are not correct,
(b) Part number of machine ECM flash
installed machine ECM or instrument
software.
cluster has wrong part number or
(c) Part number of machine ECM.
incorrect flash software installed.
Replace incorrect machine ECM or
instrument cluster with a module that
has correct part number. Flash correct
software (WP 0052 00).