TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1. If each resistance measurement is
2. Check clutch 5 (third and fourth speed)
1405 06 -
solenoid energize circuit for a short to
greater than 5,000 Ohms, go to Test 3.
Cont.
ground.
2. If each resistance measurement is not
(a) Turn engine start switch and battery
greater than 5,000 Ohms, there is a
disconnect switch to OFF position (TM
short between J1-51 (wire 901 WH)
and circuit with low resistance
(b) Clutch 5 (third and fourth speed)
measurement. Replace wiring harness
solenoid remains disconnected from
in question (WP 0169 00 thru WP 0175
wiring harness.
(c) Disconnect wiring harness
00).
connector(s) from machine ECM (WP
0052 00).
(d) At ECM wiring harness connector,
measure resistance from signal contact
J1-51 (wire 901 WH) to all contacts
used in ECM wiring harness
connectors.
3. Verify diagnostic code remains active.
1. If CID 1405 FMI 06 is active, replace
(a) Inspect and clean harness connector
machine ECM (WP 0052 00).
contacts.
2. If CID 1405 FMI 06 is not active, initial
(b) Reconnect all harness connectors.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection or a
engine start switch to ON position (TM
short at a harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Check status of CID 1405 FMI 06.
0009 00-147