10
TM 5-3805-290-23-2
MACHINE ELECTRONIC CONTROL MODULE (ECM) REPLACEMENT
THIS WORK PACKAGE COVERS
System Configuration Parameters, Copy Configuration from ECM, Remove ECM, Install ECM, Flash Programming,
Copy Configuration (Program ECM)
INITIAL SETUP
Maintenance Level
References
WP 0005 00
Unit
WP 0006 00
Tools and Special Tools
WP 0007 00
WP 0008 00
Tool kit, general mechanic's (Item 96, WP 0205 00)
WP 0009 00
Shop equipment, common no. 1 (Item 77, WP 0205
Wrench, torque (Item 106, WP 0205 00)
Equipment Conditions
Adapter, communication (Item 2, WP 0205 00)
Machine parked on level ground (TM 5-3805-290-
Software kit (Item 81, WP 0205 00)
10)
Work tool lowered to ground (TM 5-3805-290-10)
Test set, electronic systems (MSD) (Item 91, WP
Parking brake engaged (TM 5-3805-290-10)
Wheels chocked
Materials/Parts
Drawings Required
Rag, wiping (Item 41, WP 0206 00)
TM 5-3805-290-23P, Figures 44, 106, and 160
Personnel Required
Estimated Time to Complete Task
MOS 62B, Construction Equipment Repairer
2.0 hr
CAU T I ON
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component
life.
The replacement ECM must have the same serial number suffix or damage to the engine may result.
N OT E
The machine is equipped with two main electronic control modules (ECMs). This work package con-
cerns the machine ECM. Refer to WP 0053 00 for replacing the engine ECM.
If mission dictates, you may need to remove an ECM from an engine not in service. Refer to the follow-
ing procedure to ensure that the configuration parameters match those in the faulty ECM. Be sure to
clear any logged codes if you use a substitute ECM.