TM 5-3805-290-23-2
TRANSMISSION AND TORQUE CONVERTER SPEED SENSORS REPLACEMENT - CONTINUED
0069 00
TORQUE CONVERTER OUTPUT SPEED SENSOR REMOVAL
0069 00
1.
Cut and discard tiedown strap (1) from wiring harness (2).
2.
Disconnect wiring harness (2) from torque converter output speed sensor (3) mounted to transmission (4).
3.
Remove torque converter output speed sensor (3) and O-ring (5) from transmission (4). Discard O-ring.
0069 00
TORQUE CONVERTER OUTPUT SPEED SENSOR INSTALLATION
1.
Lubricate new O-ring (5) with thin coat of clean oil,
install new O-ring on torque converter output speed
sensor (3), and install assembly on transmission (4).
Tighten sensor to 27 3 lb-ft (37 4 Nm).
2.
Connect wiring harness (2) to torque converter output
speed sensor (3).
3.
Install new tiedown strap (1) on wiring harness (2).
4.
Check oil level and fill transmission with oil if neces-
sary (TM 5-3805-290-10).
5.
Run engine until normal operating temperature is
reached (TM 5-3805-290-10).
6.
Drive machine and ensure transmission cycles through
all gears (TM 5-3805-290-10).
7.
Shut down engine (TM 5-3805-290-10).
8.
Check for transmission oil leaks.
427-B0178
9.
Install right-side covers on machine (WP 0107 00).
0069 00-2