2
TM 5-3805-290-23-2
HYDRAULIC OIL TEMPERATURE SENSOR REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Rag, wiping (Item 41, WP 0206 00)
Unit
O-ring
Tools and Special Tools
Personnel Required
Tool kit, general mechanic's (Item 96, WP 0205 00)
MOS 62B, Construction Equipment Repairer
Shop equipment, common no. 1 (Item 77, WP 0205
References
TM 5-3805-290-10
Wrench, torque (Item 102, WP 0205 00)
Equipment Conditions
Materials/Parts
Hydraulic system drained below sensor (WP 0137
Cap set, protective (Item 8, WP 0206 00)
Oil, lubricating, OEA-30, Arctic (Item 32, WP
Left-side covers removed (WP 0110 00)
Drawings Required
Oil, lubricating, OE/HDO-5/40 (Item 34, WP 0206
TM 5-3805-290-23P, Figure 51
Estimated Time to Complete Task
Oil, lubricating, OE/HDO-15/40 (Item 35, WP
1.0 hr
WARN I N G
Ensure battery disconnect switch is in OFF position before performing this task. Failure to follow this warn-
ing may result in injury to personnel or damage to equipment.
To prevent injury to personnel, wear protective eye covering and gloves.
C AU T I O N
Wipe area clean around sensor during removal. Plug opening after removing. Contamination of system
could result in premature failure.
N OT E
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local policy
and ordinances. Ensure all spills are cleaned up.
