TM 5-3805-290-23-2
TORQUE CONVERTER AND TRANSMISSION OIL TEMPERATURE
SENSORS REPLACEMENT - CONTINUED
0068 00
REMOVAL
1.
Disconnect wiring harness (1) from torque converter
oil temperature sensor (2) mounted to transmission
(3).
2.
Remove torque converter oil temperature sensor (2)
and O-ring (4) from transmission (3). Discard O-ring.
427-B0177
INSTALLATION
1.
Lubricate new O-ring (4) with thin coat of clean oil, install O-ring on torque converter oil temperature sensor (2), and
install assembly in transmission (3). Tighten sensor to 15 4 lb-ft (20 5 Nm).
2.
Connect wiring harness (1) to torque converter oil temperature sensor (2).
3.
Check oil level and fill transmission with oil if necessary (TM 5-3805-290-10).
4.
Run engine until normal operating temperature is reached (TM 5-3805-290-10).
5.
Drive machine and ensure transmission cycles through all gears (TM 5-3805-290-10).
6.
Shut down engine (TM 5-3805-290-10).
7.
Check for transmission oil leaks.
8.
Install right-side covers on machine (WP 0107 00).
END OF WORK PACKAGE
0068 00-2