TM 5-3805-290-23-2
TRANSMISSION AND TORQUE CONVERTER SPEED SENSORS REPLACEMENT - CONTINUED
0069 00
TRANSMISSION OUTPUT SPEED SENSORS REMOVAL
0069 00
N OT E
The following procedure is for transmission output speed sensor 1. The procedure for the remaining three
transmission output speed sensors is identical.
1.
Cut and discard tiedown strap (6) from wiring harness (7).
2.
Disconnect wiring harness (7) from transmission speed output sensor (8) mounted to transmission (4).
3.
Remove transmission output speed sensor (8) and O-ring (9) from transmission (4). Discard O-ring.
427-B0179
0069 00
TRANSMISSION OUTPUT SPEED SENSORS INSTALLATION
1.
Lubricate new O-ring (9) with thin coat of clean oil, install O-ring on transmission output speed sensor (8), and install
assembly on transmission (4). Tighten sensor to 27 3 lb-ft (37 4 Nm).
2.
Connect wiring harness (7) to transmission output speed sensor (8).
3.
Install new tiedown strap (6) on wiring harness (7).
4.
Check oil level and fill transmission with oil if necessary (TM 5-3805-290-10).
5.
Run engine until normal operating temperature is reached (TM 5-3805-290-10).
6.
Drive machine and ensure transmission cycles through all gears (TM 5-3805-290-10).
7.
Shut down engine (TM 5-3805-290-10).
8.
Check for transmission oil leaks.
9.
Install right-side covers on machine (WP 0107 00)
END OF WORK PACKAGE
0069 00-3/(0069 00-4 Blank)