TM 5-3805-291-10
Operation Section
General Information
In a multiple camera system, the operator can
i02727240
override the automatic view by either of the following
Modes Of Operation
selections:
SMCS Code: 7348
Selecting "Manual Mode" on the display
Automatic Mode for the Single
Pressing the "Alternate Camera" switch
Camera System
In the "Automatic" mode, automatic selection of each
camera will be enabled and the appropriate camera
The single camera system is available only with
will be activated. In automatic mode, the display can
the automatic mode "enabled". The single camera
also be placed in "Standby".
system can be placed in "Standby" if the system is
congured. Refer to the "Standby" for an explanation
Note: The preferred camera view will always be
of the "Standby" option.
shown on the display screen unless the display is
placed in "Manual" mode.
Manual mode is intended for use only with the
multiple camera applications. Manual mode is
Alternate Camera Switch
disabled for use in a single camera system.
Note: If the "single camera" system can be placed in
The Alternate camera switch allows the third camera
manual mode, notify Unit Maintenance.
to be activated. In the example of the Off-Highway
Truck, the third camera is the side camera. The
In a single camera system, the system will
switch is a momentary switch that will need to be
automatically display the camera view that is based
held down in order to activate the third camera. The
on current machine operation which is determined by
image on the display will return to the front camera
the system conguration. For example, WAVS may
or the rear camera when the switch is released.
be congured to display the view from a rearward
This action is dependent on which of the cameras
looking camera when the operator selects reverse
that the machine is trying to activate. If the switch is
gear.
congured, this switch may also be providing power
to a light that concentrates on the viewing area of
the side camera. If the system is congured this way,
Standby
the light will turn on any time that the third camera is
activated with the Alternate camera switch.
Your single camera system installation may be
congured with the "Standby" feature that is enabled
or disabled. If "Standby" is enabled, the display
will remain dark unless the camera view has been
activated by machine operation. Standby may be
useful at the following times:
Travel at night.
Reverse will not be used.
If the "Standby" feature is disabled and if the
display is on constantly, the operator has the option
of adjusting the brightness of the display. If the
"Standby" feature is disabled and if the display is on
constantly, the operator has the option of adjusting
the contrast of the display.
Automatic Mode for a Multiple
Camera System
When the system is in the automatic mode, the
system automatically selects the preferred camera
view that is based on current machine operation
which is determined by the system conguration. For
example, WAVS may be congured to display the
view from the rearward looking camera when the
operator selects reverse gear.
0004 00-64
