TM 5-3805-291-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
Table 2. MID 081 Powertrain System - Continued.
TROUBLE-
CID
SHOOTING
FMI
FAULT
PROCEDURE
CODE
DESCRIPTION
FAULT CONDITIONS/EFFECTS
PAGE
0562 14
Caterpillar Monitoring
This diagnostic code is recorded when the powertrain ECM can not
System Special
communicate properly with the monitoring system powertrain ECM. A
Instruction
portion of the Data Link information requested by the powertrain ECM
is not being received. This code is generated when the powertrain ECM
has the incorrect software installed, the Caterpillar Monitoring System
ECM has the incorrect software installed, or incompatible software is
installed.
0585 02
Speed Sensor
This code is recorded when the powertrain ECM reads the speed sensor
(Transmission Output
signal as being erratic, intermittent, or incorrect. There are two speed
Speed 1) Data Erratic,
sensors for transmission output speed, the transmission output speed
Intermittent, or Incorrect
(TOS) sensor 1 (leading) and the transmission output speed (TOS)
sensor 2 (trailing). The powertrain ECM determines the existence of
this diagnostic code by comparing the signals from sensor 1 and the
signals from sensor 2. This diagnostic code is recorded when one of the
sensors shows a valid speed signal above the minimum and the other
sensor signal is zero. The diagnostic code will be active when the signal
from TOS Sensor 1 (leading) to the powertrain ECM is incorrect. when
this code is generated, transmission control may be unable to determine
the direction of travel, shift quality may be reduced. and the
transmission control will be unable to determine ground speed.
0590 02
Electronic Control
This failure results in events that are logged against an ECM that can
Module (Engine) Data
not be explained. The powertrain ECM cannot communicate with the
Erratic, Intermittent, or
engine ECM or the powertrain ECM appears to work intermittently.
Incorrect
0590 09
Electronic Control
This diagnostic code is recorded when the powertrain ECM does not
Module (Engine)
receive expected information from the engine ECM for a period of more
Abnormal Update
than five seconds. when this code is generated, the failure results in
events that are logged against an ECM that can not be explained
directly. The Engine ECM cannot communicate with this ECM or the
ECM appears to communicate intermittently.
0590 14
Electronic Control
This diagnostic code is recorded when the powertrain ECM is not
Module (Engine) Special sending the necessary parameters to the implement ECM at the proper
Instruction
rate. The update rate for parameters that are generated by the powertrain
ECM is not correct. The communication failure may be due to
disconnected connectors or a faulty wiring harness. This code is
generated when the powertrain ECM has the incorrect software
installed, the implement ECM has the incorrect software installed,
incompatible software may be installed, or the fuse for the powertrain
ECM may have failed. When this code is generated, some implement
functions may not work properly.
0007 00-15
