TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 1. MID 036 Engine Control - Continued.
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0261 11
Connectors for engine speed/timing sens rs are keyed to prevent installation of
o
wrong connector on a sensor.
This code indicates wiring to sensors has wrong polarity.
1. Check connections to engine speed/timing
sensors (WP 0076 00 or WP 0078 00).
2. Verify wires between engine speed/timing
If wires between engine speed/timing
sensors and ECM connector have not been
sensors and ECM connector have been
switched. Refer to Electrical Schematic for
switched, replace wiring harness in
more information (WP 0237 00).
question (WP 0195 00 thru WP 0201 00).
Perform Engine Speed/Timing Sensor
0261 13
Calibration Test (WP 0013 00).
Perform 5V Engine Pressure Sensor Supply
0262 03
0262 04
Circuit Test (WP 0013 00).
Perform User Defined Shutdown Input Circuit
0267 02
Test (WP 0013 00).
Perform Engine Pressure Sensor Open or Short
0274 03
0274 04
0275 03
Circuit Test (WP 0013 00).
0275 04
Perform Engine Fan Control Solenoid Circuit
0291 05
0291 06
Test (WP 0013 00).
Perform CAT Data Link Circuit Test (WP 0013
0296 09
00).
Connect MSD (WP 0005 00) and update ECM
1. If flash files are correct version, there
0296 12
flash files. Check that correct version of flash
may be an electrical problem with CAT
files have been installed in both engine ECM
Data Link circuit or in a connector.
Refer to CAT Data Link Circuit Test
and transmission ECM.
2. If flash files are not the latest version,
connect MSD equipped with ET to
diagnostic connector and install flash
files. Verify original problem has been
resolved.
Perform Engine Speed/Timing Sensor
0342 08
Calibration Test (WP 0013 00).
Perform CAT Data Link Circuit Test (WP 0013
0596 09
00).