286
TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE
Table 1. MID 036 Engine Control.
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
For a better understanding of each sysem, review the appropriate section in The-
t
ory of Operation (WP 0003 00).
These procedures may give direction to re lace wiring harnesses. However, limited
p
repair of wiring harnesses is authorized. Refer to Electrical General Maintenance
Instruction (WP 0022 00) for the correct repair procedures.
When directed to use a bypass harness and breakout Ts, refer toElectrical General
Maintenance Instructions (WP 0022 00) for the correct hook-up procedures.
Perform Injector Solenoid Circuit Test (WP
0001 05
0001 06
0002 05
0002 06
0003 05
0003 06
0004 05
0004 06
0005 05
0005 06
0006 05
0006 06
Perform Throttle Position Sensor Circuit Test
0041 03
0041 04
0091 08
Perform Engine Pressure Sensor Open or Short
0094 03
0094 04
0100 03
Circuit Test (WP 0013 00).
0100 04
Check 5V supply wire for an open circuit.
0100 10
Check for supply voltage on pin A of sensor
1. If supply voltage is not 5.0 0.2 VDC,
connector.
open circuit may be in wire to sensor or
in connector. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
2. If supply voltage is 5.0 0.2 VDC,
replace sensor (WP 0079 00).
Perform Engine Temperature Sensor Open or
0110 03
0110 04
Short Circuit Test (WP 0013 00).
Perform Electrical Power Supply Circuit Test
0168 00
0168 01
0168 02
Perform Engine Temperature Sensor Open or
0172 04 0174 03
0172 03
Short Circuit Test (WP 0013 00).
0174 04
Perform Engine Speed/Timing Sensor Circuit
0190 08
Test (WP 0013 00).