TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(e) Use Messenger to check each wire for
0367 03 - Continued.
nicks or signs of abrasion in insulation.
(f) Check for moisture at connectors.
(g) Check connectors for dirty or corroded
contacts.
(h) Check each pin and each socket of
wiring harness connectors.
(i) Reconnect all connectors.
1. If wiring harness connectors are tightly
connected and free of corrosion, go to
Test 2.
2. If wiring harness connectors are in need
of repair, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
2. Check switch circuits in harness.
(a) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(b) Disconnect wiring harness connectors
from powertrain ECM and ride control
switch (WP 0048 00 and WP 0063 00).
(c) At harness connector for switch,
connect a jumper wire between contact
4 (wire G766-GN) and contact 3 (wire
G767-WH).
(d) At harness connector for ECM,
1. If resistance is less than 5 Ohms, go to
measure resistance from contact J2-46
Test 3.
(wire G767-WH) to contact J2-45
2. If resistance is greater than 5,000 Ohms,
(wire G766-GN).
circuit is open. Replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
3. Check switch ground circuit.
(a) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(b) Wiring harness connectors remain
disconnected from ECM and switch.
(c) Remove jumper installed in Test 2.
0009 00-17