TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(e) At wiring harness connector for
1. If continuity checks do not agree with
0368 03 - Continued.
powertrain ECM, check continuity to
schematic, go to Test 2.
ground of open contacts and grounded 2. If continuity checks agree with
contact for each position of
schematic, go to Test 3.
transmission autoshift switch. Activate
and deactivate each position of
transmission autoshift switch.
2. Check transmission autoshift switch.
(a) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(b) Wiring harness connectors remain
disconnected from the powertrain
ECM.
(c) Disconnect wiring harness from
transmission autoshift switch (WP
0055 00).
(d) Check continuity of contacts for each
1. If continuity checks do not agree with
position of transmission autoshift
schematic, replace autoshift switch (WP
switch. Activate and deactivate each
0055 00).
position of transmission autoshift
2. If continuity checks agree with
switch.
schematic, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for a short to +battery.
At wiring harness connector for powertrain
1. If continuity exists, wiring harness is
ECM, check continuity from each switch
faulty. Replace wiring harness in
contact to all sources of battery voltage.
question (WP 0195 00 thru WP 0201
00).
2. If continuity does not exist, exit this
procedure and repeat procedures. If
cause is not found, replace powertrain
ECM (WP 0063 00).
0009 00-22
