TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0368 03
427-C1619
N OT E
Ensure diagnostic code CID 0368 FMI 03 is active before performing this proce-
dure.
The following procedure can create other fa lts that can be detected by powertrain
u
ECM. Ignore these created faults and clear the created faults when original diag-
nostic code is corrected.
1. Check for an open circuit.
(a) Operate machine (TM 5-3805-291-
10).
(b) Connect MSD (WP 0005 00) and check
status of CID 0368 FMI 03 while
activating and deactivating each
position of autoshift switch. Note
results.
N OT E
If code does not remain active during operation of switch, this could indicate a
possible open circuit (which corresponds to switch position) in harness.
(c) Turn battery disconnect and engine
start switches to OFF position (TM 5-
3805-291-10).
(d) Disconnect wiring harness connectors
from powertrain ECM (WP 0063 00).