TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Measure resistance between contact 2
0367 03 - Continued.
(wire C216-BK) of wiring harness for
switch to frame ground. Note
resistance.
(e) Measure resistance between contact 5
(wire C216-BK) of wiring harness for
switch to frame ground. Note
resistance.
(f) Measure resistance between contact 8
(wire 200-BK) of wiring harness for
switch to frame ground. Note
resistance.
(g) Measure the resistance between
1. If resistance is less than 5 Ohms, go to
contact 9 (wire 200-BK) of the wiring
Test 4.
harness for the switch to frame ground. 2. If resistance measurement is 5,000
Note resistance.
Ohms or greater, circuit with 5,000
Ohms or greater measurement is open.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
4. Check switch operation.
(a) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(b) Reconnect ride control switch (WP
0055 00).
(c) Wiring harness connectors remain
disconnected from powertrain ECM.
(d) Check the continuity of contacts for
1. If continuity checks do not agree with
each switch position. Activate and
Table 11, replace ride control switch
deactivate each switch position. Refer
(WP 0055 00).
to Table 11, "Ride Control Switch
2. If continuity checks agree with Table
Status" in this work package.
11, go to Test 5.
5. Check if diagnostic code remains active.
(a) Inspect contacts of harness connectors
and clean harness connectors.
(b) Reconnect all harness connectors.
(c) Operate machine (TM 5-3805-291-
10).
0009 00-18