TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) At wiring harness connector for
1. If continuity checks do not agree with
0368 02 - Continued.
powertrain ECM, check continuity to
schematic, go to Test 2.
ground of open contacts and grounded 2. If continuity checks agree with ground
contact for each position of
and open combinations, go to Test 3.
transmission autoshift switch. Activate
and deactivate each position of
transmission autoshift switch (WP
2. Check transmission autoshift switch.
(a) Disconnect wiring harness from
transmission autoshift switch (WP
0055 00).
(b) Check continuity of switch contacts for 1. If continuity checks do not agree with
each position of transmission autoshift
schematic, replace autoshift switch (WP
switch. Activate and deactivate each
0055 00).
position of transmission autoshift
2. If continuity checks agree with
switch.
schematic, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for a short to +battery at wiring
1. If continuity exists, wiring harness is
harness connector for powertrain ECM.
faulty. Replace wiring harness in
Check continuity between each switch
question (WP 0195 00 thru WP 0201
circuit and contacts J1-31, J1-39, and J2-47.
00).
2. If continuity does not exist, exit this
procedure and repeat procedures. If
cause is not found, replace powertrain
ECM (WP 0063 00).
0009 00-20
