TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) At wiring harness connector J1,
1. If wiring harness is correct, go to Test 3.
0673 02 - Continued.
measure resistance between contact J1- 2. If there is an open circuit in wiring
4 and contact J1-5.
harness (wire E906-OR or wire E907-
GY), replace wiring harness in question
(WP 0195 00 thru WP 0201 00).
3. Check signal for short.
(a) Remove jumper between contacts 1
and 2.
(b) Reconnect speed sensor 2 to wiring
harness (WP 0093 00).
(c) At wiring harness connector J1,
measure resistance between contact J1-
4 and all possible sources of positive
voltage and at all possible sources of
ground.
(d) At wiring harness connector J1,
1. If wiring harness is correct, go to Test 4.
measure resistance between contact J1- 2. If there is a short in wiring harness, short
5 and all possible sources of positive
is between signal circuit (wire E906-OR
voltage and at all possible sources of
or wire E907-GY) and circuit with low
ground.
resistance. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
4. Check if diagnostic code is still present.
(a) Clean wiring harness connector
contacts.
(b) Reconnect all wiring harness
connectors.
(c) Start engine and run at low idle (TM 5-
3805-291-10).
(d) Operate machine. Transmission must
be engaged in a direction and in a speed
and machine must be moving (TM 5-
3805-291-10).
(e) Use messenger to check whether CID 1. If diagnostic code is present, go to Test
5.
0673 FMI 02 diagnostic code is present
(TM 5-3805-291-10).
0009 00-65
