TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check solenoid energizer circuit for short.
1403 06 - Continued.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Solenoid remains disconnected from
wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
1. If each resistance measurement is
(d) At wiring harness connector, measure
greater than 5,000 Ohms, go to Test 3.
resistance from signal contact J1-66
(wire 754-BU) to all contacts used in
2. If each resistance measurement is not
wiring harness connectors for ECM.
greater than 5,000 Ohms, short is
between J1-66 (wire 754-BU) and the
circuit with low resistance
measurement. Replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Check status of CID 1403 FMI 06.
1. If CID 1403 FMI 06 is active, exit this
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1403 FMI 06 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-124
