TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1404 06 - Continued.
wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector, measure
greater than 5,000 Ohms, go to Test 3.
(wire 755-OR) to all contacts used in
wiring harness connectors for the
greater than 5,000 Ohms, short is
ECM.
between J1-49 (wire 755-OR) and
circuit with low resistance
measurement. Replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Check status of CID 1404 FMI 06.
1. If CID 1404 FMI 06 is active, exit this
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1404 FMI 06 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-128