TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1404 13
Ensure you have repaired any condition that would cause other active diagnostic
codes related to this solenoid. For example, CID 1404 FMI 03 or FMI 05 are not
active when CID 1404 FMI 13 is active. If other diagnostic codes are active, trou-
bleshoot those codes first, then perform this procedure.
Ensure diagnostic code CID 1404 FMI 13 is active before performing this proce-
dure.
Perform Fill Time for Transmission Clutch 1. If CID 1404 FMI 13 is active, verify
MSD - Calibration (WP 0014 00).
correct software has been flashed into
the powertrain ECM, or correct ECM is
installed on machine. Repeat
calibration. If diagnostic code is still
active and the cause of diagnostic code
is not found, replace powertrain ECM.
Verify that solenoid and associated
circuits are correct before you replace
powertrain ECM (WP 0063 00).
2. If CID 1404 FMI 13 is not active,
resume normal operation.
1405 03
427-C1638
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when the
original diagnostic code is corrected. Ensure diagnostic code CID 1405
FMI 03 is active before performing this procedure.
1. Check solenoid energizer circuit for a short
to +battery circuit.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness connectors
from clutch 5-2nd (WP 0203 00)
solenoid and powertrain ECM (WP
0063 00).