TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1403 13
Ensure you have repaired any condition that would cause other active diagnostic
codes related to this solenoid. For example, the CID 1403 FMI 03 or FMI 05 are not
active when the CID 1403 FMI 13 is active. If the other diagnostic codes are active,
troubleshoot those codes first, then perform this procedure.
Ensure diagnostic code CID 1403 FMI 13 is active before performing this proce-
dure.
Check calibration.
Perform Fill Time for Transmission Clutch 1. If CID 1403 FMI 13 is active, verify
MSD - Calibration (WP 0014 00).
correct software has been flashed into
powertrain ECM or correct ECM is
installed on machine. Repeat
calibration. If diagnostic code is still
active and cause of diagnostic code is
not found, replace powertrain ECM
(WP 0063 00). Verify solenoid and
associated circuits are correct before
you replace powertrain ECM (WP 0063
00).
2. If CID 1403 FMI 13 is not active,
resume normal operation.
1404 05
427-C1637
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1404
FMI 05 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).