TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Check status of CID 2129 FMI 06.
1. If CID 2129 FMI 06 is active, exit this
2129 06 - Continued.
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace the powertrain ECM (WP 0063
00).
2. If CID 2129 FMI 06 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
2274 02
427-C1642
N OT E
Status for transmission direction switch#2 contains wire numbers and connector
contacts. Use this information to troubleshoot failed circuit (please see table at the
end of this work package).
The following test procedure may create other diagnostic codes. Ignore these diag-
nostic codes and clear diagnostic codes when the original diagnostic code is cor-
rected. Ensure diagnostic code CID 2274 FMI 02 is active before performing this
procedure.
1. Check for open circuit.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect harness from powertrain
ECM (WP 0063 00).
(c) Activate switch. At harness connector 1. If resistance check does not agree with
Status for the Transmission Direction
for the ECM, check resistance to
Switch #2 (Table 13) in this work
ground of normally closed contacts and
package, go to Test 2.
normally open contacts.
2. If resistance agrees with values in the
Status for the Transmission Direction
Switch #2 (Table 13) in this work
package, go to Test 3.
