TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check signal circuit for short to ground.
0350 04 - Continued.
(a) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
(b) Disconnect position sensor from
wiring harness (WP 0085 00).
(c) Disconnect wiring harness
connectors J1 and J2 from
implement ECM (WP 0060 00).
(d) At connector for implement ECM, 1. If resistance is greater than 5,000 Ohms,
measure resistance between contact
go to Test 3.
J2-32 (wire C530-BU) and ground 2. If resistance is less than 5,000 Ohms,
in connector J1 and connector J2.
short is between signal circuit (C530-
Also, measure resistance between
BU) and a ground source. Replace wiring
contact J2-32 and frame ground.
harness in question (WP 0195 00 thru
WP 0201 00).
3. Check for +battery at sensor.
(a) Reconnect all wiring harness
connectors.
(b) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).
(c) At wiring harness connector for
1. If voltage is correct, go to Test 4.
sensor, measure voltage from
2. If +battery circuit has failed, replace
contact A to contact B.
wiring harness in question (WP 0195 00
thru WP 0201 00).
4. Check if diagnostic code remains active.
(a) Clean wiring harness connector
contacts.
(b) Reconnect all wiring harness
connectors.
(c) Observe status of diagnostic code.
(d) Operate machine (TM 5-3805-291-
10).
0009 00-178
