TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check for proper ground at sensor.
0351 03 - Continued.
(a) Wiring harness remains connected
to sensor.
(b) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
1. If resistance is less than 5 Ohms, go to
(c) At wiring harness connector for
Test 3.
sensor, measure resistance from
contact B to frame ground.
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
3. Check wiring harness of position sensor
for open circuit.
(a) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
(b) Disconnect wiring harness from
position sensor (WP 0089 00).
(c) At wiring harness connector for
sensor, connect a jumper wire
between contact B and contact C.
(d) Disconnect wiring harness
connectors from implement ECM
(WP 0060 00).
(e) At wiring harness connector for
1. If resistance measurement is less than 5
implement ECM, measure
Ohms, go to Test 4.
resistance between contact J2-33
2. If resistance is greater than 5 Ohms,
(wire H718-GY) and contact J1-70
replace wiring harness in question (WP
(wire C214-BK).
0195 00 thru WP 0201 00).
4. Check wiring harness of position sensor
for short to +battery circuit.
(a) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
(b) Wiring harness remains
disconnected from position sensor.
Remove jumper wire installed in
Test 3.
(c) Wiring harness connectors remain
disconnected from implement
ECM.
0009 00-183