TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Replace sensor (WP 0089 00) and
1. If new sensor corrected diagnostic code,
0351 00 - Continued.
recalibrate sensor (WP 0017 00).
resume machine operation.
Recheck diagnostic code. Observe ON/
2. If diagnostic code indicator is active,
OFF status of diagnostic code indicator
recalibrate sensor. Perform calibration
as tilt linkage position sensor is fully
for tilt linkage position sensor again.
raised and lowered.
Also, verify if diagnostic code indicator
is active for this diagnostic code. If cause
is not found, replace implement ECM
(WP 0060 00).
427-C1653
N OT E
0351 03
Ensure diagnostic code is active and diagnostic code indicator is active.
The following procedure can create num rous related diagnostic codes. Recon-
e
nect all harnesses. Then, related diagnostic codes will be shown as being not
active. Complete following procedure. Then, clear all of related diagnostic codes.
1. Check for power at sensor.
(a) Do not disconnect wiring harness
connector from sensor.
(b) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).
(c) At wiring harness connector for
1. If voltage is system voltage, go to Test 2.
sensor, measure voltage from
2. If voltage is not system voltage, +battery
contact A to contact B.
circuit in wiring harness has failed.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
