TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Check switch.
0365 04 - Continued.
(a) Observe ON/OFF status of
diagnostic code indicator.
(b) Disconnect kickout set switch (WP 1. If diagnostic code indicator remains
0055 00) from wiring harness.
active, go to Test 2.
2. If diagnostic code indicator is inactive,
repeat this test to verify failure of switch.
Replace switch (WP 0055 00) or replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
2. Check wiring harness circuit.
(a) This test checks continuity of entire
wiring harness circuit that has
failed. This test includes switch that
was previously checked.
(b) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(c) Reconnect kickout set switch.
(d) Disconnect wiring harness from
implement ECM (WP 0060 00).
1. If continuity agrees with values in Status
(e) Operate switch in tilt and lift
for Kickout Set Switch, Table 10, harness
positions.
circuit is correct. Exit this procedure and
repeat this troubleshooting procedure. If
cause of diagnostic code is not found,
replace implement ECM (WP 0060 00).
2. If continuity check does not agree with
values in Status for Kickout Set Switch,
Table 10, harness circuit has failed.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-231
