TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Use messenger to ensure diagnostic 1. If diagnostic code is active, exit this
0358 03 - Continued.
code is active (TM 5-3805-291-10).
procedure and repeat this
troubleshooting procedure. If cause of
diagnostic code is not found, replace
implement ECM (WP 0060 00).
2. If diagnostic code is not active, initial
diagnostic code was probably caused by
a poor electrical connection at a harness
connector that was disconnected and
reconnected. Resume normal machine
operation.
427-C1660
N OT E
0358 05
Return lines for solenoids are joined and return lines connect to contact J2-4
(wire K927-BU) of implement ECM.
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Disconnect pilot solenoid from
wiring harness (WP 0218 00).