TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1660
N OT E
0358 06
All solenoid return lines connect to contact J2-4 (wire K927-BU) of implement
ECM.
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code has been corrected.
Ensure diagnostic code indicator is active and diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Observe ON/OFF status of
diagnostic code indicator.
(c) Disconnect pilot solenoid from
1. If diagnostic code indicator remains
wiring harness (WP 0218 00).
active, harness or implement ECM has
failed. Go to Test 2.
2. If diagnostic code indicator is inactive,
solenoid or connecting harness has
failed. Repeat this test to verify failure.
Replace solenoid (WP 0218 00) or
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
