TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check for shorted wiring harness.
0358 06 - Continued.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Solenoid valve remains
disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms,
implement ECM, measure
harness has failed. Replace wiring
resistance between contact for
harness in question (WP 0195 00 thru
failed solenoid circuit J2-2 (wire
WP 0201 00).
F852-YL) and contact J2-4 (ground 2. If resistance is greater than 5,000 Ohms
wire K927-BU).
(no continuity), harness circuit resistance
is correct. Exit this procedure and repeat
this troubleshooting procedure. Also,
recheck if diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace implement ECM (WP
0060 00).
427-C1662
N OT E
0365 04
Status for Kickout Set Switch, Table 15 at the end of this work package, contains
wire numbers and connector contacts. Use this information to troubleshoot
failed circuit.
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and diagnostic code is active.
