TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(1) Software part number for imple-
1. If all part numbers are correct, go to Test
0967 09 - Continued.
ment ECM.
2.
2. If all part number are not correct, these
(2) Software part number for mes-
modules may have an incorrect part
senger.
number and/or software configuration:
implement ECM (WP 0060 00),
messenger (WP 0056 00), or powertrain
ECM (WP 0063 00).
2. Inspect wiring harness connections.
(a) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
(b) Inspect wiring harness connections
related to CAT Data Link. Make
sure connectors are clean and
tightly connected.
(c) Check mating of connector.
(d) Check wires at connector.
(e) Check each wire for nicks and/or
signs of abrasion in insulation.
(f) Check for moisture at connector.
(g) Check for dirty contacts and/or
corroded contacts.
(h) Check each pin and socket.
1. If wiring harness connectors are tight and
free of corrosion, go to Test 3.
2. If wiring harness connectors require
repair, replace wiring harness(es) in
question (WP 0195 00 thru WP 0201 00).
3. Check for additional related diagnostic
codes.
(a) Ensure all ECMs that use CAT Data
Link are connected.
(b) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(c) Acknowledge and troubleshoot any
active diagnostic codes that are
currently displayed on message
center.
0009 00-262