TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. If no other diagnostic codes are present,
(d) Verify that no related diagnostic
0967 09 - Continued.
codes are present.
go to Test 4.
2. If other related diagnostic codes are
present, exit this procedure and perform
tests again. Verify that other related
diagnostic codes are not present.
4. Check for shorts to ground.
(a) Turn battery disconnect and engine
start switches to OFF position (TM
5-3805-291-10).
(b) Disconnect wiring harness from all
ECMs that use CAT Data Link (WP
0056 00, WP 0057 00, WP 0060 00,
and WP 0063 00).
(c) At wiring harness for implement
ECM, measure resistance between
frame ground and following data
link circuits.
(1) Contact J1-10 (wire 944-OR)
and contact J1-20 (wire 945-BR)
of implement ECM.
(2) Contact J1-6 (wire 944-OR) and
contact J1-15 (wire 945-BR) of
messenger.
(3) Contact J1-10 (wire 944-OR)
1. If resistance that is measured is greater
and contact J1-5 (wire 945-BR)
than 5,000 Ohms for each measurement,
of powertrain ECM.
go to Test 5.
2. If resistance that is measured is not
greater than 5,000 Ohms for one or more
of measurements, replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
5. Check for a short to +battery.
(a) Battery disconnect and engine start
switches remain in OFF position
(TM 5-3805-291-10).
(b) All related control modules remain
disconnected from wiring harness.
0009 00-263