TM 5-3805-291-23-1
ETHER STARTING AID REPLACEMENT - CONTINUED
0037 00
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and hoses and plug
openings after removing lines. Contamination of system could result in premature failure.
Utilize two line wrenches to avoid damage to fittings.
N OT E
Tag hoses prior to removal to ensure correct installation.
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local pol-
icy and ordinances. Ensure all spills are cleaned up.
Ether starting aid cylinder is mounted on left side of machine next to air cleaner.
REMOVAL
1.
Remove three bolts (1) and washers (2) from clips (3).
2.
Remove three clips (3) from lines (4 and 5).
3.
Remove bolt (6) and washer (7) from clip (8).
4.
Remove clip (8) from line (4).
5.
Disconnect line (4) from connector (9).
6.
Remove connector (9) and O-ring (10) from atomizer assembly (11). Discard O-ring.
7.
Disconnect line (4) from union (12).
8.
Remove line (4) from machine.
9.
Remove union (12) from line (13).
10.
Remove line (13) from union (14).
11.
Remove union (14) from line (5).
12.
Disconnect line (5) from nut (15).
13.
Remove line (5) from machine.
14.
Remove nut (15) and sleeve (16) from fitting (17). Discard sleeve.
15.
Remove fitting (17) and O-ring (18) from machine. Discard O-ring.
0037 00-2