TM 5-3805-291-23-1
THROTTLE PEDAL AND THROTTLE POSITION SENSOR MAINTENANCE - CONTINUED
0039 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for damage, wear, pitting, cracks, or corrosion and replace if necessary.
ASSEMBLY
1.
Install screw (13) and clip (14) on throttle pedal assembly (3).
2.
Install pedal (12) on throttle pedal assembly (3).
3.
Install parts kit (11) on throttle pedal assembly (3) in accordance with instruction provided with kit.
4.
Install two snap rings (8), pin (9), and roller (10) on throttle pedal assembly (3).
5.
Install grommet (7) on throttle pedal assembly (3).
INSTALLATION
Throttle Position Sensor
1.
Position throttle position sensor (4) on throttle pedal assembly (3).
CAU T I ON
Excessive torque applied to mounting screws may affect operation of sensor.
2.
Apply sealing compound to threads of two screws (6) and install on throttle position sensor (4). Tighten screws to 20 2
lb-in. (2.25 0.25 Nm).
Throttle Pedal
1.
Install four washers (2) and bolts (1) on throttle pedal assembly (3).
2.
Connect throttle position sensor (4) to wiring harness (5).
3.
Verify correct throttle operation (TM 5-3805-291-10).
END OF WORK PACKAGE
0039 00-3/(0039 00-4 Blank)
