6
TM 5-3805-292-23
FIELD MAINTENANCE
-
HYDRAULIC OIL FILTER HEAD AND PRESSURE SWITCH REPLACEMENT
0071
REMOVAL, CLEANING AND INSPECTION, INSTALLATION
INITIAL SETUP
Tools and Special Tools
Materials/Parts - Continued
0
0
Tool Kit, General Mechanic's (WP 0178, Item
O-ring (3)
0
33)
Washers
0
0
SATS (WP 0178, Item 30)
0
References
0
Materials/Parts
TM 5-3805-292-23P, Figure 50
0
0
Cleaning Compound, Solvent, Type III (WP
0
0179, Item 3)
0
Equipment Conditions
Oil, Lubricating, OE/HDO-10 (WP 0179, Item
0
Machine parked on level ground (TM 5-3805-
16)
0
292-10)
Rag, Wiping (WP 0179, Item 19)
0
0
Tag, Marker (WP 0179, Item 30)
Estimated Time to Complete
0
0
Hydraulic Oil Filter
0
1.2 Hr
0
0
WARN I N G
When servicing this machne, performing maintenance, or disposing of hazardous
i
materials, consult your unit/local hazardous waste disposal center or safety office for local
regulatory guidance. If further information is needed, please contact The Army
Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic sysem lines or fittings unless engine is shut
t
down and hydraulic system pressure has been relieved. Tighten all connections before
applying pressure. Escaping hydraulic fluid under pressure can penetrate the skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
0071-1