TM 5-3805-292-23
0146
REMOVAL CONTINUED
14. Disconnect four harness connectors (Figure 6, Item 3) from hydraulic pump (Figure 6, Item 4).
15. Remove bolt (Figure 6, Item 9), washer (Figure 6, Item 10), three ground eyelets (Figure 6, Item 11), and
ground strap (Figure 6, Item 12) from flywheel housing.
16. Remove nut (Figure 6, Item 6), washer (Figure 6, Item 7) and wire (Figure 6, Item 8) from switch (Figure 6, Item
5).
17. Disconnect two electrical connectors (Figure 6, Item 2) from charging system protection resistor (Figure 6, Item
1).
Figure 6. Hydraulic Pump Wiring.
0146