TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 21. Test Voltage to Carry
Kickout System Will Not
Kickout Position Sensor.
Operate or Operates
1. Turn battery disconnect switch and
Improperly - Continued
ignition switch to ON position
(TM 5-3805-298-10).
2. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
3. Set kickout switch to ON position
(TM 5-3805-298-10).
4. Using digital multimeter
Voltage 18 to 26 V Replace carry
(WP 0174), test for voltage
kickout position sensor (WP 0297).
between connector LE-C18
Proceed to Test Step 60.
terminal B and terminal A
Voltage Less Than 18 V Proceed to
(WP 0012, Figure 236).
Test Step 24.
Test Step 22. Test Ground Circuit to
Lift Kickout Position Sensor.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove tiedown strap (Figure 18,
Item 3) from wiring harness
(Figure 18, Item 2) and bracket
(Figure 18, Item 1). Discard
tiedown strap.
3. Disconnect connector LE-C5
(WP 0012, Figure 237) from
connector N-C1 (WP 0012,
Figure 238).
4. Disconnect connector LE-C18
from carry kickout position sensor
(WP 0012, Figure 236).
5. Disconnect connector LE-C3 from
lift kickout position sensor
(WP 0012, Figure 235).
6. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Proceed to Test Step 23.
between connector LE-C3
Resistance Greater Than 5.0 Ohms
terminal A (WP 0012, Figure 235)
Replace front frame wiring harness
and ground.
(WP 0301).
Proceed to Test Step 60.
0155-29