TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Disconnect connector C-C6
Kickout System Will Not
(WP 0012, Figure 70) from
Operate or Operates
implement disable switch
Improperly - Continued
(WP 0012, Figure 71).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Replace implement disable switch
between connector C-C37
(WP 0264).
terminal 2 (WP 0012, Figure 241)
Proceed to Test Step 60.
and connector C-C6 terminal 1
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 70).
Replace lower cab wiring harness
(WP 0291).
Proceed to Test Step 60.
Test Step 29. Isolate Fault.
1. Set implement disable switch to
lock position (TM 5-3805-298-10).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10). Wait
approximately 30 seconds before
proceeding.
3. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
4. Remove kickout fuse
(TM 5-3805-298-10).
Resistance 5.0 Ohms or Less - Install
5. Using digital multimeter
kickout fuse (TM 5-3805-298-10).
(WP 0174), measure resistance
between kickout fuse terminals.
Proceed to Test Step 30.
Resistance Greater Than 5.0 Ohms -
Discard kickout fuse.
Proceed to Test Step 37.
Test Step 30. Test for Shorted
Kickout Positioner Wiring Harness.
1. Remove two tiedown straps
(Figure 19, Item 3) from mounting
bracket (Figure 19, Item 1) and
wiring harness (Figure 19, Item 2).
Discard tiedown straps.
2. Disconnect connector N-C2 from
bucket kickout position sensor
(WP 0012, Figure 233).
3. Disconnect connector N-C3 from
fork kickout position sensor
(WP 0012, Figure 234).
0155-32