TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 23. Test Voltage to Lift
Kickout System Will Not
Kickout Position Sensor.
Operate or Operates
1. Turn battery disconnect switch and
Improperly - Continued
ignition switch to ON position
(TM 5-3805-298-10).
2. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
3. Set kickout switch to ON position
(TM 5-3805-298-10).
4. Using digital multimeter
Voltage 18 to 26 V Replace lift kickout
(WP 0174), test for voltage
position sensor (WP 0297).
between connector LE-C3 terminal
Proceed to Test Step 60.
B and terminal A (WP 0012,
Voltage Less Than 18 V Proceed to
Figure 235).
Test Step 24.
Test Step 24. Test Voltage to Front
Frame Wiring Harness.
1. If not done previously, turn ignition
switch and battery disconnect
switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector LE-C2
(WP 0012, Figure 152) from
connector C-C9 (WP 0012,
Figure 153).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
4. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
5. Set kickout switch to ON position
(TM 5-3805-298-10).
6. Using digital multimeter
Voltage 18 to 26 V Replace front
(WP 0174), test for voltage
frame wiring harness (WP 0301).
between connector C-C9
Proceed to Test Step 60.
terminal 6 (WP 0012, Figure 153)
Voltage Less Than 18 V Proceed to
and ground.
Test Step 25.
Test Step 25. Test for Open Kickout
Fuse.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove kickout fuse
(TM 5-3805-298-10).
0155-30